The water bill arrives and the consumption is higher than normal. In looking at the bill you realize it's winter time, your water consumption is down, but the bill says it is up as if its summer when your water consumption is higher. Then it hits you bathtub repair a water leak! At some point almost all homeowners run into this problem.
The repair of a ballcock tube is the simplest repair of all toilet leaks. There is a small black tube that is in the tank of the toilet that connects to the flush valve fill tube. If the tube slips from the little clasp that holds it in place, it can begin spraying water line repair in the tank and out from under the tank cover. To fix this toilet leak, simple re-attach the black tube to the clip. It really is that simple.
If you bought the same unit it should line right up, if you were unable, you will need to remove or add length to the existing piping. This may require you to splice together copper with plastic, don't let this scare you the hardware store will have all of the necessary parts.
Dishwasher. To check water leakage on your dishwasher, you will need several sheets of paper placed underneath the machine before operating it. When the machine stops, check the sheets of paper you placed underneath to see it they are wet. If so, call a maintenance person to repair the leak immediately. It is important also for you to remember that regular dishwasher uses 15 gallons on every wash load. Make sure that when you use it, the load is full.
Be certain that the bathroom exhaust fan vents to the outdoors, not into the house or attic. If the exterior vent dampers don't operate properly or water line repair don't seat well have them fixed or replaced.
68. Sea sickness: I always keep a bucket in the cockpit, much better that the sufferer is sick into a receptacle of sorts than tries to be sick over the side.
Is your garbage disposal clogged, but it is turning ok? This may be due to a blockage in the pipe. If you look at the pipe work under your sink you will see that the disposal is connected to a pipe that should join to a U bend and providing it was installed correctly it should have a connector that can be undone. If you undo this connector the pipe will pull away and generally this is where most blockages occur. Remove the blockage and reconnect the pipe.